Connecting to your LusioMATE

Connecting to LusioMATE's

• 1 - Turn on LusioMATE sensors and wait until it's connected.
  • Before all, make sure your Bluetooth and location are on!
  • On the sensors, you will see blue, red, green and again red light respectfully - Red means waiting for the connection.
  • If after these lights you see purple, it means your sensor is low-battery!

• 2 - Both Sensors will turn to green when they are connected
  • If after connecting, it's flashing green, means it's low-battery!

Note that:

• It may take up to 2 minutes, but finally, the app would find and connect to the sensors.
• If it doesn't connect, make sure your Bluetooth is ON and Wifi is connected!
• Each time you close the app it's disconnected. So if you run the app on the same device as you are reading this manual, each time you come here to check the manual and back to the app you need to wait and reconnect again.
• If you see any other colours, reset your LusioMATEs and if it repeats, contact Lusio at Letsplay@lusiorehab.com

After you connected to the devices, you need to calibrate them, 

It's very easy! See the next step of this manual to find out how!